|
Butterfield, MN | Are you only controlling left and right side, or is it split up to control more than that? If it's just left and right, you should be able to populate the pins going to pins 8 and 9 on the gray connector of the Product Control node. Take those wires and connect them to the electric side of the valve on the 12 volt signal input and disconnect them from the original wires that lead back up to the switches. If you have more than just left and right that you're controlling, you'll end up having to get an AccuBoom node, which will become more complicated, as you'll have to get a generic type cable to connect individual wires. Not really a lot worse, but just more equipment to have on the machine. | |
|