AgTalk Home
AgTalk Home
Search Forums | Classifieds (28) | Skins | Language
You are logged in as a guest. ( logon | register )

Is the AMP connector the industry standard?
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
premoj
Posted 8/10/2018 15:24 (#6922432 - in reply to #6922358)
Subject: RE: Is the AMP connector the industry standard?



Depends on what you are wiring.... power, rs232, can.... what brand... ect.

If power then yes the 3 pin type amp connectors are mostly what are used for power. But make sure you get the correct pairs, I have seen the retaining nuts on both the male and females side. Also there is some variation on keyed hot, always hot and neutral/ground. As far as power goes read the directions, some require power from the battery (ie clean power) and some don't care.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)