|
Butterfield, MN | I'm unsure about your first question. Those values are saved in the product control node, so you may have one of those that is getting flaky. It would not be a bad idea to make sure that it is up to the latest version of software (and the Viper Pro, for that matter) to see if that will cure it.
You will need to change your valve cal most likely. Depending on the valve type you have, you may be able to change around other values (if a PWM valve), such as PWM Min and Max, preset PW.
Are you slaving your lightbar to the Viper Pro? Meaning you set up the guidance based on what is on the Viper Pro and it reflects it on the lightbar. If you are, what shows up on the lightbar will not make any sense until you have a guidance line that appears on the Viper Pro ahead of time, so it's not worthwhile. Again, updating software on the Viper Pro, if it's not already at the latest, will help some, but it's not nearly as good as straight A-B by any means for helping you find the next row in Last Pass. | |
|
More Viper Pro questions.
