|
SW North Dakota | Since my son bought a new combine last year with autosteer I decided to set my old 8120 up with it also. It is autosteer ready. Picked up a used nav11 controller and had the software on both the nav and pro 600 updated. Took the 372 receiver from my quad. Found the cable to connect the nav into the harness from the cable in the arm console. So after much searching and time spent trying to figure thing out I have hit a wall that I need help with. Lets just say dont bother calling the dealer. I know that I am getting correct signal from my 372. Everything looks good there. I go to set my a-b line and I get this Cannot Engage AG060 Autoguidance switch is set to off. Locate the autoguidance disable switch and set it to enable. CANT find where to do that. I know the cable that I used to connect the nav controller had a cable on it that had a 4 pin connector. Im thinking it has to hooked to some kind of switch. Any help would be wonderful. Any other suggestions as I try to get this working?
Edited by grampak 7/5/2018 22:53
| |
|