Posted 6/30/2018 16:42 (#6842930) Subject: John Deere rate controller setup
I picked up a used John Deere rate controller to use with my 2630 monitor. I think I have it pretty well setup but I am trying to get those two outside (fence line nozzles) to operate. I have a Fast sprayer with 4 sections and have been using a Raven 450 monitor. Initially, I programmed the 2630 for a 4 section boom setup. But I couldn't get the fence line nozzles to open up. Then I set it up to be a 6 boom. Then I could get them to open. I programmed them both to the minimum width, 1 foot. But I am not sure this is the proper setup.
Is there something that I am missing here?
Appreciate any information that anyone can offer.
Thank you in advance.