|
| What’s your minimum flow set to? Sounds like you have it up way to high trying to use it to stop your nozzles going back to a dribble for when you slow down... This should be the minimum flow that your flow meter can read, or your reg valve can control(whichever is lowest). This will be the lowest flow your system ever sees when it is operating, regardless of how many sections are turned on. Use the Minimum Operating Speed setting to set a “pressure hold” speed. Using a nozzle chart, work out what the lowest speed is that you can apply at your current rate, to give you your minimum desired pressure. The Reg valve will not be controlled below this point, unless a section is switched on or off. | |
|
Field IQ rate above target
