AgTalk Home
AgTalk Home
Search Forums | Classifieds (30) | Skins | Language
You are logged in as a guest. ( logon | register )

Aim command
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
raider2b
Posted 5/13/2018 13:29 (#6758399 - in reply to #6757364)
Subject: RE: Aim command


North Dakota
The only time pwm should be used is when the sprayer is being used in conventional spraying, unless you have aim command pro.

If you can't control pressure there is a troubleshooting guide in the operators manual.

Does pressure display on the 700? The pressure on the display is from the right hand sensor. There is a way to see what the aim command pressure sensor is sending to the pressure control module, shows in the manual which pin.

If you can't set the pressure you might have a broken wire (pretty common), or a bad sensor (just as common).

Check ALL the fuses.

Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)