|
| If you want to keep your singulation and cv, you will need to keep the sensor node and load cells plugged into JD harness, then enable the ride Dynamics under the sensors tab, will need to enable all of them, or will get errors. Take the sensor and load cell out of brackets, bundle up and zip tie in front of the unit it is taken off of. If the ride Dynamics is disabled and sensor node removed, 2630 will only monitor population. For the air compressor if it is a set point, plug the two air lines coming out of the valve, then set the margin to 15 lbs, ( lowest it will let set to ) keep the electric air compressor on unit as it will purge air out at key cycle, or will need to fill tank manually as needed. Hope this helps. | |
|