|
|
central iowa | I know on our 635b i could access any stored codes in the left hand screen in the dash, but i cannot remember what button pushes to do to find them. and owners manual doesnt say,
Guessing shop manual does, but it isn't here where i am lol.
Have a dt225b that is giving autoguide problems and need to see if any codes are stored that might point in the right direction since mechanic is over a day away.
Thanks
|
|
| |
|
Flanagan, Illinois | Hold the up arrow until the left screen changes. Then arrow over to dcerr(dash errors) or tcerr(trans. errors)and hit okay to view stored codes. |
|
| |
|
central iowa | slims - 4/26/2018 18:16
Hold the up arrow until the left screen changes. Then arrow over to dcerr(dash errors) or tcerr(trans. errors)and hit okay to view stored codes.
thanks a bunch
|
|
| |
|
Flanagan, Illinois | What problems are you having with it? |
|
| |
|
central iowa | slims - 4/26/2018 20:38
What problems are you having with it?
suddenly wouldn't find or stay on a line. mechanic stopped by tonight and is pretty sure it is the wheel angle sensor (so was i but with no computer program to check it ) Sadly they are well known for failure and almost everyone i know with one of these tractors (red yellow or orange) have had them replaced at some point. Hopefully will get if fixed for sure tomorrow and know for sure.
|
|
| |
|
| Let me know how bad of a job it is to change the sensor. |
|
| |
|
Flanagan, Illinois | It is not to bad of a job, it sits under the top king-pin on the left front
planetary |
|
| |
|
central iowa | slims - 4/27/2018 08:48
It is not to bad of a job, it sits under the top king-pin on the left front
planetary
Yeah, shop manual doesn 't make it look too tough, but there is some intricate pieces to go in there and you have to have the dealer laptop to set it up anyway, My day job is too busy now, so i will write a check for this fix.
|
|
| |
agco error codes
