|
NW KS | It can be done but it would really depend on what two machines you are moving parts between. I took a kit that was on a 1688 and was able to move it to a gleaner combine. This was about a best case scenario. The top cover for the gleaner combine was a flat piece of steel and the grain flow sensor mounted directly on the flat top cover. I was able to find some photos of the actual sensor to give me some idea of where everything should be mounted. I was also able to get the housing that bolts to the clean grain elevator to fit. I had to make some extra brackets but it did work. When I calibrated everything it came out to with-in a few percent.
| |
|