AgTalk Home
AgTalk Home
Search Forums | Classifieds (77) | Skins | Language
You are logged in as a guest. ( logon | register )

Trimble Roll Calibration
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
torn
Posted 4/16/2018 15:12 (#6713588 - in reply to #6713352)
Subject: RE: Trimble Roll Calibration


roaming
bcochran79 - 4/16/2018 11:27
I have tried the pry bar method, but I have always found that small inconsistencies in the dirt can make the prybar track to one side as much as an inch or more. It is important that I get the roll cal right so that I don’t end up incorporating any roll cal error into my equipment offset for the planter. I have run into this before and it can be very frustrating.

Put a 1" piece of ready rod through the hitch pin hole, just long enough to scratch a line in the dirt. Nuts and washers on top and bottom to lock it in place, and you have an upgraded version of the prybar method, which should provide better performance.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)