|
Ohio | We are trying to get a Satel Radio to work with a TMX 2050. We have the port expander set for port D. Configured Port D for the correct Input baud rate and data. This same setup works with a FMX (same settings) and a GFX 750. It works when we go to manual guidance but when we enable the autopilot the RTK fix goes away. One small victory has been when we go to ag remote and configure base id from 1 to 0 and we get a fix for 30 seconds until that setting gets reset by the monitor and the fix goes away. At a loss for what to do next as Trimble wants to close the case due to it being "unsupported" even though i specifically states in the firmware release notes that RTCM input is supported in this version. Frustrated and need some hopefully good advice. We tried the same setup with a Bluetooth and NTRIP and it worked just fine although it was a different TM200 and Monitor. We have tried different Nav controllers with the same results. | |
|