disker - 4/5/2018 13:13
Hi All,
I have a Pro700 that I am trying to use to control a Raven 660 on a lime spreader. I have the Raven cable to go from the 660 to Pro700 but have heard I need an adapter cable to add ground on pin 5 of the 9 pin on bottom of Pro700. Is this correct?
Yes. Order CNH part number 87732647.
disker - 4/5/2018 13:13
To throw another little glitch in mix my Pro700 is in a non Case tractor with a universal ISO harness that is sending GPS to Pro700 through the 26 pin connector, pins 9 and 10. Is this incoming GPS going to mess up my ability to do the Raven connection. My plan was to grab a ground off pin 14 and add it to pin 5 out bottom connection.
Sound correct?
Sounds fine. Incoming GPS should cause no problems.
Last question, is there a certain end of Raven cable that goes to Raven and certain end that goes to Pro700 as it looks like it can go either way.
Thanks Again
Doesn't matter. |