Posted 2/23/2018 19:16 (#6600139) Subject: New Product To Fix Worn Parallel Arms And Bushings
Hi everyone, We are just getting this new product up and going after working on it for two years and want to invite you to check out our website. We now have a hardened flange bushing that is installed in the parallel arms that comes in 1 1/16” and 1 1/8” OD both with a inner OD of 7/8” to be used with our hex bushings and bolts. These flange bushings will keep the arms from ever needing work in the future and are almost twice as hard as the hex bushings. Because we have a wider surface area and fix the worn and punched holes they make a row much tighter than before. If you watch the first video on our website you can see the difference between new OEM arms and ours. All hex bushings are now 7/8” OD so you just need to know what size the parallel arms require to make the hole round again.
Wanted to add that a lot of these post are from before we had the flange bushing that goes into the parallel arm so there is talk about the different sizes of hex bushings we offered. All hex bushings are now 7/8" OD and are used with the flanged bushing that comes in 1 1/16" and 1 1/8" OD