|
Morris, IL | Your did great, it will do just what you want. I thought of doing similar without grade control but wanted to do too much flat work. I though I could run flat ground with a inclinometer and water level, I only have water level on but I would have been dead wrong. Going up hill I think chain would be most useful.
Assuming you have Integra then gradient was the older system disregard that, cheaper probably just use agleader parts plug and play like all your other implements which is what I do.
I though it was good buy, it is just a 3 point and older pro plow but i’m happy with it. So far one tractor has pulled it 4’ deep with 6” boot. Have only ran few pickup loads of min rolls so far, 6” main and few 4” wet spot runs. I actually walked out today look at them we are quite wet here wanted to make sure looked ok. Great feeing seeing first ripen flowing don’t know why. You will spend 2x more time getting setup and getting supplies then you actually will putting tile in.
Edited by NEILFarmer 2/24/2018 20:46
(5E964949-F1A8-473C-AF54-1A6D8E43B661.jpeg)
(7F8D15A0-1162-4F92-B5B9-EDDF45232E24.jpeg)
Attachments ---------------- 5E964949-F1A8-473C-AF54-1A6D8E43B661.jpeg (287KB - 154 downloads) 7F8D15A0-1162-4F92-B5B9-EDDF45232E24.jpeg (265KB - 170 downloads)
| |
|