|
Tennessee | We bought an accuguide ready Magnum 260 that someone had been steering with a Trimble display. They had an autosense steering sensor on the tractor, but for some reason they unhooked the harness, pulled it back into the cab, and rolled it up behind the nav. Would you remove auto sense and use the factory sensor? Or run the wires back down and use auto sense? If I remote auto sense, there is also a red wire going into the Nav. Can I just cut this wire? Or should I remove it from the harness? It is the red wire with the black loom.
Edited by zkeele 2/14/2018 09:33
 (20180214_083755.jpg)
Attachments
----------------
 20180214_083755.jpg (119KB - 119 downloads)
| |
|
Auto Sense on Magnum 260
