|
| How long are the shots? The only info I could find is here:
http://ravenprecision.force.com/knowledgebase/articles/Tech_Tip/Val...
Where it says:
"Valve Cal 2 is used for Fast Close valves. It is the time in milliseconds that the system sends a burst of 12 volts to the valve to
open it. The default number is 200, but it can be adjusted to fine tune the valve control."
So the full on time is about 200 ms. The shots must be less than that. The reason I am asking is to make a controller for the valve.
| |
|
Raven Fast Close valve
