|
| When you connect your tractor (Nav2-box?) to 262 port 1 (on A plug) it will autoconfigure also the settings on port 2 (on B plug). Only Port 3 (on B plug also) remains as set before by Ag Remote.
To avoid repeatedly readjusting the receiver with AgRemote you should use port 3 also for Viper.
You can T the tx wire from port 3 to go both to Viper and Digifarm bt-dongle.
And set the NMEA output from receiver port 3 fast enough for Viper (10-20Hz?).
If this uses too much cellular data then you could use phone/tablet position instead of 262 receiver position on your NTRIP client.
I do not have a Nav2 box myself, but I assume this does the same thing as an EZ-500 and 252 as an external TSIP receiver: when U connect it to port 1 it will autoconfigure port 2 also...
But not port 3 setting...
Edited by Artic 1/25/2018 01:10
| |
|