|
| I had an used 252 RTK for couple of years. It was a low cost way to do RTK on an old EZ-Guide 500.
I fed the correction steam into port C (=port 3 on B connector as the manual says) after finding some instructions from this board.
I assume U have already learnt how to use AgRemote to set up the Receiver for that.
I would assume that 262 is like 252 but do not know for sure.
The pin outs are all in the manual. But I will enclose 2 pictures.
One from manual and one from my wires before heat sinking. The right "B" plug has: 5 ground 6 and 8 for data and 10 (red) +12V to feed blue tooth dongle...
Hope this is for help.
https://talk.newagtalk.com/forums/thread-view.asp?tid=696849&Display...
Edited by Artic 1/23/2018 19:43
(Clipboard01.jpg)
(IMG_20151010_151135.jpg)
Attachments ---------------- Clipboard01.jpg (97KB - 58 downloads) IMG_20151010_151135.jpg (72KB - 49 downloads)
| |
|