|
northeast ohio | Certainly some AgTalk members with JD experience will chime in with ideas. If the 6210R is AutoTrac(tm) ready but your 7800 is not, then there is a color blind option that might be worth exploring. Trimble has a solution called AutoPilot Motor Drive which is a EZ Pilot motor with a NAV 2 / 3 instead of the IMD 600 controller. What you would do is install the motor on the 7800 and swap the display along with the NAV controller between tractors. This works with at least the CFX 750 and TMX 2050 displays. I believe your 6210r will need to unlocked to allow the Trimble equipment to function. Regardless, this scenario of using the NAV controller in both tractors should give you excellent performance at the diversity of speeds described.
Recently, I was told that the new Trimble GFX 750 display with its NAV900 antenna can be unlocked to directly control a CAN tractor and further unlocked to run the EZPilot motor without a NAV. The price of these unlocks is apparently less than a NAV3 controller. Currently this display has limited capabilities with regards to controlling multiple products or seed monitoring, but these are functions you are not needing.
Interested in comments to these suggestions from Trimble experts
http://trl.trimble.com/docushare/dsweb/Get/Document-803568/AP_MD_In...
Edited by neo_ag 12/27/2017 20:55
| |
|
Assisted steering for 7800/6210r
