|
Butterfield, MN | You have two options if it's Raven AutoBoom. You can either run with the small display, which is ok, and probably a little less expensive than the other alternative. The other alternative is to swap out the current AutoBoom node for an ISO AutoBoom node. They look identical and will plug in place of each other. Then you'll need to get the CAN system adapted over to plug into the plug on the Integra cabling. I'd assume that this will be the only thing on that BUS anymore if you are removing the Raven product control, so should work fine to do that. | |
|
Running raven autoboom with Integra
