|
Black Stump | Tedbear,
This is also SteerCommand and InCommand 1200. Different problem to yours though - yours sounds like the SteerCommand is not getting good power. What FW version etc of the ECU and display? Where is the display cable connected?
My problem brings up the error 58. Also throws a communication issue on the gen4. If you start your display too early or late you have probably experienced this at some stage. This tractor is also being used with an ISO sprayer so if you don’t turn the incommand on the gen 4 display decides that it will reconfigure itself so not fun there.
We were also seeing problems in some other machines where the Deere remote support was not paid and the tractor throwing communication errors part way down a run. That was fixed by pulling a fuse.
I hope this has described the problem a little better.
Cheers
Pipes | |
|
GS4 warm boot vs cold boot
