AgTalk Home
AgTalk Home
Search Forums | Classifieds (20) | Skins | Language
You are logged in as a guest. ( logon | register )

Does a totally full clean grain elevator mess with the AgLeader impact sensor?
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
LHaag
Posted 11/11/2017 10:36 (#6358455 - in reply to #6354641)
Subject: RE: Does a totally full clean grain elevator mess with the AgLeader impact sensor?



Colby, Kansas
The relationship of grain flow to sensor output is curvilinear, thats why with a linear calibration your worst errors are typically at low and high flow rates. What I think you were seeing Daniel is that especially at those high flow rates, that are close to capacity, it takes more calibration points to fit that curve so that you can really distinguish the differences between flow rates that are at the relatively high end of the range. As has been discussed below, I think if you put a few more points in across the upper end of the range and run the full multi-point cal things will clear up.


Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)