|
Manitoba | At the start of harvest it took about 5 trys before my new to me 2162 header would go through all the calibration steps. It would time out on the 4th step. Which measures pressure or something like that.
Now before the soybeans I was going to calibrate it again. I should have left it alone! Now it always times out on the 4th step. Question as well is should the header be in flex mode when calibrating? Couldn't find a clear answer in manual. This is on an 08 8010. My dealer updated the software on it last fall but they're saying it could be a software glitch. Any experience with this? | |
|