AgTalk Home
AgTalk Home
Search Forums | Classifieds (2) | Skins | Language
You are logged in as a guest. ( logon | register )

Greenstar won't recognize receiver
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
RobCam
Posted 9/11/2017 16:15 (#6241605 - in reply to #6237094)
Subject: RE: Greenstar won't recognize receiver


Check your terminators. Every time I've had a receiver not show up on the CAN it was a terminator issue (normally had this on tractors). I've seen the GreenStar documentation and recording side of things not recognize the implement/combine before, usually take a key cycle like you said. Dead give away is the recording source on the equipment page, if it's anything besides AUTO and grayed out, you have an issue. If yield and moisture show up through the original GreenStar and it's not the terminators, it sounds like software. Or since it happened over winter, a mouse chewed through a wire in your roof.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)