Posted 9/7/2017 15:45 (#6234574 - in reply to #6233809) Subject: RE: Yield Monitor advice
Some questions first. Did you use the neighbor's display only or did it have a processor too? I don't think the display going bad would cause loss of data. But there could be a problem with the mobile processor although I have never had a problem. Is it possible the missing data was caused by the height switch either set too high or malfunctioning? Also could be loss of GPS signal? Have you inspected your mass flow sensor and impact plate? Does moisture sensor seem to operate? You can manually dump the moisture sensor to see if motor sounds ok. Just some things to check before spending big bucks.