AgTalk Home
AgTalk Home
Search Forums | Classifieds (44) | Skins | Language
You are logged in as a guest. ( logon | register )

Intelliview monitor questions
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
torn
Posted 8/11/2017 09:42 (#6180468 - in reply to #6170948)
Subject: RE: Intelliview monitor questions


roaming
henk1122 - 8/6/2017 14:57

Mm. I couldn't get it to work quickly. I didn't have a gps signal in the shed, but i'm not sure if that has to do with it. I got an error that there is no communication. In the harvester arm chair, is it the blue or red wire I should be connecting to? According the pinout in the pdf I linked in my previous post, it should be cavity F, which is the red wire. However, when I compare it with the 26 pin connector, it should be the blue one.. So i'm not sure now if I'm using the correct wire.

-- EDIT
Seems that the pinout diagram is kinda wrong. In the end, I had to connect pin 3 of the serial connector on the back of the EZ Guide 500 to the red wire in the connector in the arm chair. Got it working now and created some nice yield maps! :) Only can't find a way to display the yieldmap directly on the IntelliView II screen.

The IntelliView II will log yield maps, but you cannot see an onscreen map.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)