|
| I have a 335 John Deere round baler that for some reason will only make a quarter of a bale before the belts start to squeal and than shear a pin. Belts are the required length and I replaced the drive roll. I know its not a belt problem and I'm pretty sure its not a bearing problem. No hot bearings or squeaks. I borrowed a friends tension relief valves (because they're to expensive to buy just for the hell of it) to see if that would do the trick. He has the same baler. Nothing is working I'm pulling my hair out because my 1st crop is going by and I'm sitting here helpless. Even the local dealer service tech said he couldn't help. Anyone have any ideas? | |
|