|
St Peter MN | I have a 930 MoCo that has a hole in the gear case housing under one of the cutterheads. I see I can get just one section to replace, my question is, how do you go about removing that section. It's of course in the middle of the cutterbar. Guessing the whole cutterbar has to come out and start disassembling from one end? Bought this thing used of course and have been waiting for a month and a half for a manual from Deere. Part #18 is what I need to replace. Going to try welding it tomorrow, but it's cast so I don't have high hopes for that working. Thanks
(moco.jpg)
Attachments ---------------- moco.jpg (122KB - 103 downloads)
| |
|