|
SW Ohio | Trying to set up a pressure sensor on my sprayer with a greenstar rate controller. On the advice of another thread here, I am using a honeywell sensor, p/n PX2AN1XX200PSAAX and I have it wired correctly into my rate controller (checked several times). I can backprobe the pins at the sensor and I get 5v on the a terminal, ground on b, and about 3.5v on the signal wire when there is no pressure against it. I have tried everything I can think of and cannot get pressure reading on my 2600 screen. Any ideas?? | |
|
Greenstar rate controller pressure sensor
