|
| We have a 12/23 1245 planter. Got it pulled out today and hooked up to the tractor, as we are looking to start planting this week. Everything hooked up and worked as it should. I did all the calibrations I normally do and started setting up all of the products in the monitor. After I got all of that set up, I went to run it across the barnyard a few times to make sure everything was working properly. Then the monitor started chirping at me...Bulk Fill #1 rate out of range followed by Bulk Fill #1 at max flow. Both faults state to check hydraulics and verify product and distance calibrations. Not sure what this means or what I have done, but I can't get the bulk fan motor to come on at all now. Any ideas at all? Thanks.
Brady | |
|