|
NW IL | I have 6500/SteerCommand. Currently running 3rd party cell modem for RTK correction on port B of 6500. We are trying to feed GPS from SteerCommand to JD 2630. The 2630 is being used to control a JD exact emerge planter. Currently we can not get the JD 2630 to recognize the signal from SteerCommand
Current settings in SteerCommand NMEA out port settings are: GGA 5 hz RMC 5hz 19200 baud. I'm pretty sure JD 2630 also needs GSA turned on. There is no options to turn on GSA in SteerCommand.
If I connect port B of 6500 to 2630 I can get GS3 to recognize GPS if I set up as GGA 5 hz RMC 5hz GSA 5 hz 19200 baud.
Running SteerCommand firmware "ECU-S1-v3.8.33024". Any suggestions to get SteerCommand to send GPS to JD GS3?
Edited by swenzel 4/29/2017 16:55
| |
|