Posted 2/10/2016 11:04 (#5101287 - in reply to #5101202) Subject: RE: JD 3020 front axle help
Pics are up. Yes that is a Schwartz. We always did the heat and beat. You may be able to find another Schwartz cheap, neighbor sold one set on 30's for $300.
Posted 2/10/2016 12:25 (#5101531 - in reply to #5101515) Subject: RE: JD 3020 front axle help
Northwest Iowa
Drive wedges of some type into the splits to help open up. Lots of squirrel pee or hagen's brew. Then start trying to rock the outside leg with a loner bar into the adjustment holes. The steering arms may need to be taken off and put in a press. You'll get them but there will be lot of tools laying around the job before you are done.
Posted 2/10/2016 13:30 (#5101690 - in reply to #5101196) Subject: RE: JD 3020 front axle help
Black Hawk County, IA
Put the wheel back on and let it down, then gently drive against a tree to rotate the axle in the tube. A chain at bottom of the spindle and a skid loader might get it also. J
Posted 2/10/2016 18:54 (#5102330 - in reply to #5101196) Subject: RE: JD 3020 front axle help
kirby,Ohio
unbolt the tie rod and find a long breaker bar that can fit in one of the axle tube hole and try it should rock it free. it Always help me on my 4020's and 4000 and 4320 oh and a hammer too
I see it didn't take mark long to take the 3020 after he called me asking how much would it cost him when I said high would $3000. to paint it but no biggy just remember to pull the syco sifter out of the dash so it isn't black
hard to believe that every thing that been done to it that they didn't want a factory john deere wide front under it I know where there is 2 or maybe 3 at ...... LMAO