|
Bonanza, Or | I installed the Nav controller II and the ezguide 500 today along with all the mods to the wiring harness in my 08 MX215. Several issues ,so here we go.
How do I know if my tractor is equipped with ISO 11783 so I know whether to leave power connectors plugged together or not? In the fuse panel it has a 10 amp fuse in the ISO 11783 slot but the power connectors were plugged together where the nav controller goes.
The ez 500 which I have set to use autopilot powers up and will acquire a signal from the nav controller ( power light is blinking on nav controller) but it tells me I have an invalid vehicle and will not engage. After reading the end of the directions I think I don't have everything to complete this install because it says "connect and run the AgGPS Autopilot Toolbox II software". That is where it talks about selecting the vehicle type.
What do I need to finish this up? | |
|
|
MX215 autosteering
