|
Spink County, SD | I've got the new Precision Air 2280 across about 400 acres now, and am just getting the all run blockage monitors to work (kinda) Apparently, the sensors had not been assigned to a "Shoot" and as such werent reporting any blockages, however, when i flip a switch (say to turn off the starter fertilizer) it will report an error for no flow. How can i stop this? I have the switch turned off for that tank, it shouldnt be reporing no flow.
Additionally, i started getting big red screen errors today saying that communications had been lost with the ECU for the flow monitors, then the flow icon on the bottom of the VT page would dissapear, most of the time it would then reappear after a round or two, only to fail again with the same error.
Any ideas at all? | |
|