|
MN | The PF90363 cable is used for communication from the GS2 controller to other non deere controllers. The John Deere GPS receiver sends out data on the RS232 wires out of the receiver on pins 3 and 10. These wires have no mates to them on the tractor side of the plug in. We have been making a harness to go from the connector down and into the cab. There is a harness from Deere PF90350 that will Y into the receiver connector and then you can run that down into the cab. It also has the radar wire ran in it as well if you are using a ITC receiver.
Edited by lukerduke 4/2/2008 23:20
 (pf90350.jpg)
Attachments
----------------
 pf90350.jpg (92KB - 416 downloads)
| |
|
JD 2600 Starfire itc GPS out
