|
| Depending on the reciever you are using will determine which port to use for the simulated radar output. If using a Phoenix 200 or Invicta 115, you will use port A. If using a Phoenix 300 or Invicta 210/310, you will use port B. Looking at your past posts, it appears you have a Phoenix 200 or 115. If this is the case, you will use port A. The speed signal is output on pin 1. Raven has an adapter cable, so you can still utilize the port if drawing the speed signal from it. The part number is 115-0171-216 and can be purchased through your local Raven dealer. This cable will have a three pin round connector that typically hooks to a Raven controller. You will pull off one of the three pins for your speed signal.
Edited by ZELGY 4/4/2008 11:26
| |
|