|
Sunnyvale, CA | Pin 1 - V(+) in
Pin 2 - V(+) out
Pin 3 - CAN_H
Pin 4 - EXT Switch in
Pin 5- RS-232 Rx
pin 6 - RS-232 Tx
Pin 7 - Signal GND
Pin 8 - Signal GND
Pin 9 - Radar out
Pin 10 - CAN_L
Pin 11 - V(-) out
Pin 12 - V(-) in
On cable 64045 (all port cable) all pins are connected as follows:
Pins 1 and 12 connect through a fuse to vehicle power
Pins 2,3,10, and 11 connect to a 4-pin Deutsch for CAN/power to or from the EZ-Steer cable. same pin out as for the EZ-Guide 500 CAN connector
pins 4,8, and 9 go to a 3-pin deutsch for coverage loggin in and radar out. Same restriction about putting in voltages to these pins. Isolate with a relay instead of connecting directly to the master boom switch.
pins 5,6,7 are for RS-232 (NMEA) and go to a DE-9(M) connector with the same pinout as the EZ-Guide 500 and EZ-Guide Plus for these three wires.
| |
|