AgTalk Home
AgTalk Home
Search Forums | Classifieds (36) | Skins | Language
You are logged in as a guest. ( logon | register )

Connecting a Trimble reciever to Greenstar
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
Francis
Posted 2/22/2008 06:46 (#316439 - in reply to #316234)
Subject: Re: Connecting a Trimble reciever to Greenstar


Redfield, SD
Yes. The way you do this depends upon the system voltage. If it is a 2.5volt system, you will need a mobile processor, keycard with field doc and mapped based prescriptions and a PF90277 field doc connect harness. Your Trimble receiver will have to have the following NMEA strings on - GGA, GSA, and RMC; the baud rate needs to be set to 4800, Data Bits 8, Parity none, Stop bits 1, Flow control none. If you have the older 4/5 volt system, in addition to the above you will need a 2.5 volt cab harness with ISO implement connector and a Can Transition Bridge. I cannot remember the part number for the transition bridge, when I find it I will post the number. Either way this will work. Hope this helps.
Transition Bridge BA28777 $577

Edited by Francis 2/22/2008 06:56
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)