Posted 1/31/2008 22:15 (#298018 - in reply to #297960) Subject: Re: GPS signal from Starfire ITC to CHI AFS Pro600
roaming
The Pro 600 can accept signal from any receiver, as long as the communication protocol is correct. Run GPS into the 9-pin connector on the bottom of the Pro 600. Not sure what cable is required; ask your JD dealer for a serial cable for your receiver. Receiver must be configured to output NMEA at 4800 - 38400bps, Data bits = 8, Parity = None, Stop bits = 1. Hertz rate = 1hz or 5hz.
GPS signal from Starfire ITC to CHI AFS Pro600
