AgTalk Home
AgTalk Home
Search Forums | Classifieds (2) | Skins | Language
You are logged in as a guest. ( logon | register )

Abs plastic fabricators/welders?
View previous thread :: View next thread
   Forums List -> AgTalk CafeMessage format
 
iseedit
Posted 11/11/2012 19:43 (#2691617 - in reply to #2690110)
Subject: RE: OK, so here it is...



central - east central Minnesota -

guessrow - 11/10/2012 23:27

As you can see, I have two fenders instead of 4. I'd just prefer to figure things out now while it's easy to change ;^) I like this design (the 90 deg bend at the base may not be there in the end) right now. 4 individual 'arched' fenders welded to flat pieces may be simpler. I just envision this piece as plastic as opposed to steel or fiberglass. To give an idea of scale: the model is 24" wide 32" front to back and about 27" to the top of the backrest. good luck -jim

 

edit: anyone know of a plastic fabricator who could do this?


Nice . . . Needs a cup holder built in? There Is a place in Maple Lake that likely could do the job . . . Rhino plastics  http://www.rhinoroto.com/    Or MayWes, not far from you ~ they maybe better then rhino for security of you idea?



Edited by iseedit 11/11/2012 20:05
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete all cookies set by this site)