As you can see, I have two fenders instead of 4. I'd just prefer to figure things out now while it's easy to change ;^) I like this design (the 90 deg bend at the base may not be there in the end) right now. 4 individual 'arched' fenders welded to flat pieces may be simpler. I just envision this piece as plastic as opposed to steel or fiberglass. To give an idea of scale: the model is 24" wide 32" front to back and about 27" to the top of the backrest. good luck -jim edit: anyone know of a plastic fabricator who could do this?
Edited by guessrow 11/11/2012 00:32
 (wheelchair-Layout2.jpg)
 (wheelchair-Layout1.jpg)
Attachments
----------------
 wheelchair-Layout2.jpg (46KB - 63 downloads)
wheelchair-Layout1.jpg (33KB - 64 downloads)
| 
Abs plastic fabricators/welders?
