SW part of the "Cyclone" State!! | Since you have the 750 and RTX already, I would put the Autopilot platform kit on your Deere that is going to be AT ready. Since it is ATR, it is just a cable kit to tie into and run Deere's valve. Cable kit is $1495 and $5000 for a new Nav II. The only way to use RTX is by running a Trimble receiver at this time. The Paradyme is costly and you could not use the RTX. You'll then need to get NMEA GPS out of the Nav II diagnostic connector to feed signal to your Integra.
Edited by Bleed CIH Red 11/10/2012 09:54
|