Lac qui Parle County Minnesota | Was finishing up a field before all the rain, last Saturday. A couple rounds left, no hurries, life is good, and I catch the unloading (NH TR86) on the corner of a gravity wagon and crinkled the tube and bent the auger slightly. (Okay, just in case your wondering, referring to the post below, I always keep the auger IN. I guess this is one case where keeping it OUT would have prevent this. Oh well..) Any way, have the replacement tube and we attempted to straighten out the auger. We have it pretty good but while turning it, the flighting seems good but when you watch the bearing holders there is a slight wiggle, less than an 1/8 inch, closer to 3/16th. Am I being to anal about getting it close to no wobble, or is some tolerable? Any ideas on how to get out that last bit or just forget, use it, and it should be fine? |
Bent unloading auger
