|
South Australia | Clyde i doubt (although i cannot be 100% certain) that this would work. The KEE and Farmscan steer controllers are very different (kee doesn't use a wheel angle sensor to start). Where did u read that it would work? KEE also doesn't support pivots nor does it allow you to save curves (well to my knowledge it does not (i have 2 x15's although they are not exactly up2 date)). I am assuming (just by the equipment that you are using) that you are in Australia. Have you talked to farmscan about pivots and whether they will put it in there software? Does anyone actually know what is happening with farmscan? What type of signal are you using with your current setup? Have you asked other companies about trading you farmscan system for one that does support pivots (ie trimble, autofarm, beeline)? | |
|
kees zynx software
