|
| We are doing some updating and calibrating on a autopilot system. We are running FMD 3.0, NavII 4.4,
252 receiver 3.56. This is a RTK system. I would like a explanation of what the following actually do
and how they effect each other. P gain, Dead Zone, aggr on run screen, acquire line aggr. The system is
following the line well. I get some wheel wiggle when starting on the line and it takes awhile to get dead on,
but then it stays right on line. Going forward and back at start of line does not really help getting lined up.
Also I think the 252 update sets the mask from 13 to 10. Should we set back to 13 for RTK? Thanks for
any information. | |
|
trimble autopilot
