AgTalk Home
AgTalk Home
Search Forums | Classifieds (127) | Skins | Language
You are logged in as a guest. ( logon | register )

Implement work switch wiring on 9420?
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
SaptonAcres
Posted 3/10/2007 03:15 (#117628 - in reply to #117284)
Subject: RE: Implement work switch wiring on 9420?



Hazelridge, Mb
I know when we got our 9520 a couple years ago, dealer told me to look in behind the plastic shroud underneath the back window on the outside of the cab (this was before the 2600 display). There was a two pin weather pack connector there on the right side (can't remember if it was male or female). I plugged the implement switch from the air drill to it, and as long as the implement is down (switch is either open or closed depending how you set it up on the GS2) and you are moving the switch will beep and show recording. It will stop recording once you stop with the implement down, but begin again when you start moving again.

Once we switched over to the 2600 display this setup still works.

Try checking there if you have a chance.

Andrew
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)