|
SE North Dakota | The wire in pin #1 of the starfire connector (which is the pin you were using in the past to get the speed signal out of the receiver) goes down inside the cab and there is a single wire connector behind the scv display and the one in front of it ( I can't think of what it is called right now). Just take out the phillips screw between the 2 and pull them out and there should be the connectors back there. They are single wire and one is marked GPS and one is marked Radar. Whichever one is plugged in to the tractor is the speed source the tractor is using. If you are using the radar for the tractor performance monitor, just plug into the one marked GPS which is not being used and go to the DB9 connector. | |
|
GPS out to NEMA on 8430T
