|
Ohio | Did you remove the wire from the slot that holds the cap on? If so I have applied hydraulic pressure to force the cap out, it will come out and will make a mess. A groove gets wore into the cylinder where that cap wire holds it in position, just needs a little force. Good luck on the seals, those cylinders are build for Kelly and nothing else fits very well. I have got generic seals from HERSH Packing in Columbus, Ohio and worked OK. I have also bought 2 new cylinders from Kelly through Buckeye Tractor 740-363-1341 and they are not cheap $$$. I think it's a poor design for the end cap to hold. | |
|