|
Victoria Australia | I have a queston regarding calibrating my new insight on my seeder useing granular product through the spreader control.I have the direct comand so am not using a second controller.We have input the megalitre weight of the grain and then weighed the amount as it comes of the seedre belt , hten put in the new calibration figure . This seems a slow way to calibrate, is it possible to input actual weight ( kilos ) instead of the volume weight.Other controllers I have calibrated seem to weigh the actual weight of product after a certain number of pulses from the shaft sensor but the Insight wants to know the volume weight.Am I doing something incorrectly and is there a way to input actual product weight that comes of a belt system . | |
|